Month: March 2022

Cisco G0/25—Huawei G0/0/1 Cisco G0/27—Huawei G0/0/2 Huawei switches support two link aggregation modes: manual and lacp-static. If no configuration is applied, the switch defaults to manual, so you must manually change the mode to lacp-static. This is important, otherwise it cannot successfully negotiate LACP with a Cisco switch. Huawei Switch #interface Eth-Trunk1 port link-type trunk port trunk allow-pass vlan 2 to 4094 mode lacp-static //Change the link aggregation mode max active-linknumber 2 //Set the maximum number of active links to

Example: Configuring Link Aggregation in Manual Load Balancing Mode Networking Requirements As shown in Figure 1, SwitchA and SwitchB are each connected to VLAN 10 and VLAN 20 networks through Ethernet links, and a large volume of data traffic is exchanged between SwitchA and SwitchB. The user wants to provide greater link bandwidth between SwitchA and SwitchB so that devices in the same VLAN can communicate with each other. The user also wants a certain degree of redundancy to ensure

I. Common Issues with Deploying DHCP Services Setting up a DHCP server allows network parameters such as IP addresses, subnet masks, default gateways, and DNS servers to be assigned automatically to clients, which simplifies network configuration and improves management efficiency. However, there are some problems in the management of DHCP services, the most common of which are: · Rogue DHCP servers · DoS attacks against the DHCP server, such as DHCP exhaustion attacks · Users assigning IP addresses arbitrarily, causing